1. Introduction
Femtosecond laser-assisted cataract surgery (FLACS) irradiates an extremely short femtosecond pulse laser, thereby performing minimally invasive and accurate cataract surgery without causing shock or heat [
1]. By irradiating the laser as if to create perforations, we allow adjacent perforations to connect to each other. We repeat this process, and perform anterior capsulotomy and lens fragmentation. Depending on the distance between two adjacent perforations, and the setting of each laser energy amount, the eye can be irradiated with a variety of designs. Depending on the design, the amount of total laser irradiation energy is determined. An important difference from conventional manual cataract surgery (CCS) is that gas generation occurs within the lens during the laser irradiation, which is laser irradiation-energy-dependent [
2,
3]. Thus, there is a higher risk for laser-induced gas to increase intracapsular pressure and cause intraoperative capsular block syndrome (CBS), leading to posterior capsule rupture during FLACS as compared to CCS [
1,
3,
4]. Posterior capsule rupture during cataract surgery is a complication that must be avoided because it prevents the intraocular lens from being inserted into the capsule. However, the behavior of the generated gas inside the lens during femtosecond laser irradiation and the effect on the lens capsule are yet to be well understood. The risk of capsule rupture due to the CBS could be related to the properties of laser-induced gas distribution and the lens capsule dilation caused by gas pressure. Therefore, the aim of this study was to investigate the behavior of the femtosecond laser-induced gas inside the lens and then determine its influence on the lens capsule. In order to achieve this objective, we observed porcine crystalline lenses during laser irradiation and measured the posterior capsule position (PCP) by using an intraocular endoscope in the vitreous cavity. Furthermore, optical coherence tomography (OCT) was used to measure the anterior chamber depth (ACD) before and after laser irradiation, and after measuring the equatorial perimeter of the extracted lenses; values were then compared with untreated porcine lenses as controls. The present results suggested that there was inflation of the laser irradiation-induced gas in the direction of the posterior capsule beyond the lens irradiation site along with expansion of the lens capsule, which could be involved in the development of CBS.
2. Materials and Methods
The ethics committee of Jikei University ruled that approval was not required for the study.
Porcine eyes: This study used 6-month-old porcine cadaver eyes (N = 26) that had been obtained from a local abattoir and stored at 4 °C. All eyes were used within 12 h of enucleation. Out of the 26 total eyes, 16 were laser-irradiated, while 10 were used as controls.
Femtosecond laser lens irradiation procedure: We used femtosecond laser cataract surgical system CATALYS (Johnson & Johnson Surgical Vision Inc., Santa Ana, CA, USA), which includes the use of laser irradiation for lens fragmentation and quadrants. After connecting the liquid optic interface (and endoscope) to the porcine eye (
Figure 1), we manually customized the anatomic dimensions (e.g., anterior and posterior corneal curvature, anterior and posterior capsule). Since the thickness of the porcine lens made it impossible to detect the posterior capsule when using the installed OCT, the tentative PCP was manually set so that lens thickness was 6.5 mm. Depending on the distance between two adjacent perforations and the setting of each laser energy amount, the laser could be irradiated with a variety of designs. Depending on the design, the CATALYS system determines the total amount of laser energy to be delivered. In order to evaluate the influence of the emerging gas bubbles, we varied the lens fragmentation setting (energy of lens fragmentation) for each set of experiments (
Table 1).
Anterior chamber depth measurement: The installed OCT was used to measure the ACD pre- and post-laser irradiation in 5 eyes (lenses E, G, H, and I in
Table 1). The OCT measurement after laser irradiation took less than 1 min. ACD correlations between pre- and post-laser irradiation were statistically analyzed by a Wilcoxon signed-rank test using IBM-SPSS software (SPSS, Inc., Chicago, IL, USA). The ACD change ratio was calculated by dividing the ACD after laser irradiation by the ACD before laser irradiation. The correlation between ACD change ratio and laser total energy was statistically analyzed by a simple regression analysis using IBM-SPSS software.
Endoscopic imaging and lens posterior capsule position measurement: Before customizing for anatomic dimensions, a 23-gauge trocar cannula (AU-1272EA2-06 DORC, Netherlands) was inserted into 6 eyes (F, G, H, I, K, P in
Table 1) at a site that was located 6 mm from the corneal limbus. A 23-gauge intraocular endoscope (AS-611: Fiber Tech, Tokyo, Japan) that was connected to a 3 LED light-source device (FL-301: Fiber Tech, Tokyo, Japan) and 3 CMOS HD camera (FC-304: Fiber Tech, Tokyo, Japan) was inserted via the trocar, and then fixed to make it possible to image the back of the lens including the posterior capsule (
Figure 1). Imaging of the posterior site of the lens was performed using this endoscopic device during the femtosecond laser irradiation of the lens.
After obtaining the endoscopic image, a graph of the ratio of the position of the posterior capsule per each 5 s of laser irradiation was prepared. Calculations were performed on the basis of the assumption that 1 was the value obtained by subtracting the PCP before laser irradiation from the postmaximal inflated capsule position. These values were defined as the PCP ratio. Since the laser irradiation time in the five lenses that did not rupture due to the laser irradiation differed among lenses, the graph is shown as the normalized time graph with a total irradiation time of 1. After determining the regression line for the prepared graph, the coefficient of determination was calculated.
Microscopic imaging and lens-equatorial-perimeter measurement: After fragmentation and quadrants of the lens by femtosecond laser irradiation, the lens was extracted and imaged using a microscope (SMZ 18: Nikon, Tokyo, Japan). After excluding eyes destroyed by irradiation or during lens extraction, the equatorial perimeter of the crystalline lens in 10 eyes (lens A, C, D, E, G, H, I, J, K, L in
Table 1) was measured using Image Processing and Analysis in JAVA program (Image J, National Institute of Health, Washington, DC, USA) and then compared with the control lenses from 10 eyes. The equivalence of the equatorial perimeter between control and laser-irradiated lenses was statistically analyzed by a Mann–Whitney U test using IBM-SPSS software. Correlation between the equatorial perimeter of the laser-irradiated lens and total laser energy was statistically analyzed by simple regression analysis using IBM-SPSS software.
4. Discussion
The present results suggest that femtosecond laser lens irradiation generates gas that expands towards the posterior capsule in conjunction with the amount of laser energy, which subsequently leads to the expansion of the posterior capsule. Although the sample size was small, the reason for not finding correlation between ACD change ratio and the amount of laser irradiation energy may be related to the fact that gas distribution is predominantly on the posterior capsule side, and the difference in distensibility between anterior and posterior capsules. During laser irradiation, generated gas causes an increase in the IOP by raising the lens capsule’s internal pressure, with the increase in the IOP dependent on the amount of the laser energy [
5]. The increases in the lens capsule’s internal pressure caused by the generated gas can lead to intraoperative CBS. Although the laser irradiation settings used in this experiment were within the range that can be set in usual surgery, as the amount of laser energy increased, this led to an excessive amount of generated gas and potential ruptures in the capsule due to the occurrence of CBS during laser irradiation. Therefore, laser irradiation needs to be set at a level that avoids the generation of excessive gas. In addition, careful attention needs to be paid to intraoperative CBS avoidance to prevent pressure-handling issues that can occur in procedures such as hydrodissection, in which there could be an increase in inner lens capsule pressure after laser irradiation [
3,
6,
7].
This study focused on the behavior of gas found inside the lens capsule, which is the visible part of the generated gas, along with examining its influence on the lens capsule. However, pH acidification occurs in the aqueous humor due to the invisible part of the gas (carbon dioxide) [
8]. This finding suggests that FLACS may influence ocular tissue due to currently unknown chemical changes and generated substances [
9]. Since these changes are not reported for conventional cataract surgeries, additional investigations into these issues need to be undertaken.
There are several limitations in this study. First, it is possible that the size of the crystalline lens of the porcine eye may not be the same for individuals, and between the left and right eyes. However, it is difficult to accurately measure changes in lens diameter before and after laser irradiation, as laser crystalline lens irradiation by a clinical FLACS device cannot be performed after extracting a crystalline lens and accurately measuring the lens diameter. Second, in order to observe the extracted lens in this experiment, lens fragmentation was performed without performing anterior capsulotomy. If anterior capsulotomy had been performed, the behavior of the gas and the amount of energy that causes the capsule to burst might have been different from that observed in the actual experiment. However, since a large amount of the gas was distributed towards the back during actual clinical FLACS in combination with anterior capsulotomy and lens fragmentation, the phenomenon in this experiment was not wrong as a whole.
In summary, femtosecond laser porcine lens irradiation generated gas in the lens, with the extent of this increase dependent on the amount of laser irradiation energy. The generated gas moved beyond the irradiation site and expanded the posterior lens capsule. If the capsular pressure exceeded the maximal pressure levels, this could cause a capsule rupture. Thus, since there was an increase in capsular pressure due to the gas generated after femtosecond laser irradiation, careful attention needs to be paid to the laser irradiation setting and procedures such as hydrodissection in order to prevent further intracapsular pressurization and the possibility of capsule rupture.