Biomechanics, Volume 3, Issue 2 (June 2023) – 9 articles

Background: The aging process contributes to the decline in physical capacity that leads to loss of independence in performing life activities. Immobility and instability are the most significant predictors and indicators of physical disability and dependence. As a result, a variety of assistive devices exist to address immobility and instability in older adults, including walkers, canes, crutches, wheelchairs and handrails. Sit-to-stand (STS) transitions are the most common transitions in daily mobility activities. The ability to perform STS transitions successfully is therefore one of the most important activities to focus attention on. As a result of physical deterioration, older adults will sooner or later be faced with their physical limitations, and in particular, will not be able to provide enough torque at critical body joints to make the STS transition. Aim: This paper suggests employing two-arm assistance using two handles located symmetrically in the body’s sagittal plane. During the aging process, people are faced with varying levels of muscle deterioration and body constraints and consequently require different levels of assistance to complete the transition successfully. This paper aims to develop a tool to find the optimum handle location for people based on their body constraints to reduce knee torque (identified as the critical joint in the STS transition). These findings are also used to measure the effects of assistive device handle position on the biomechanics of the two-arm assisted STS transition. Methods: For this purpose, a theoretical tool was developed by integrating human body kinetics with a multi-objective genetic algorithm to find the optimum hand force required at the seat-off point for a set of potential handle locations. The tool was set to achieve the minimum knee torque within the defined body constraints and assumptions. In line with the physics of the STS transition, the “seat-off point”, when subjects lose their seat support, was chosen as the most challenging point of the task. This was coupled with the “nose over toes” posture recommended to older adults by occupational therapists. Results and Discussion: The schematic of the developed tool shows that the best handle locations requiring the minimum torques at the body joints are positioned in handle zone 2, where the handles are placed vertically above the knee and below the hip joints and horizontally located ahead of the hip and behind the knee joints. Within this handle zone, both components of the hand forces (vertical downward and horizontal backward) provide assisting torque to all the body joints and consequently reduce the torques required at body joints. Full article

When performing the traditional barbell back squat, athletes may experience discomfort in the shoulders or be limited by shoulder mobility. The Squatbar^® is a barbell designed to be ergonomic to the shoulders but has never, in the scientific literature, been compared to the traditional Olympic barbell. Thus, the current study investigated kinematics, kinetics, and myoelectric activity (EMG) between the Squatbar^® barbell and the Olympic barbell when performing a one-repetition maximum (1-RM) back squat. Twelve strength-trained men (body mass: 83.5 ± 7.8 kg, age: 27.3 ± 3.8 years, height: 180.3 ± 6.7 cm) performed a 1-RM squat with both the Olympic and Squatbar^® barbells. The paired samples t-test revealed significantly more weight was lifted with the Olympic barbell compared to the Squatbar^® barbell (148 ± 21 kg vs. 144.5 ± 20 kg) and was accompanied by greater shoulder external rotation (74 ± 7.5° vs. 59.6 ± 9.2°). No differences in joint kinematics of the lower limbs, kinetics, or EMG were observed between the two barbells. The results of the current study indicate the Squatbar^® to be a suitable substitution for the Olympic barbell for athletes with reduced shoulder mobility when performing the squat. It was concluded that the Squatbar^® induces similar kinetics, kinematics, and EMG when compared to the Olympic barbell, except for reducing external rotation of the shoulder. Full article

The aim of this study was to assess center of mass (COM) acceleration and movement during change of direction (COD) maneuvers during a competitive soccer game to elucidate situation-specific demands of COD performance. This information can assist in developing soccer-specific tests and training methods. Fifteen elite-level female youth soccer players were tracked for one game with inertial measurement units (IMU) attached to the lower back. COD movements in combination with situational patterns were identified using high-speed video. LASSO regression was used to identify the most important predictors associated with higher vertical peak accelerations (PA_v) of the COM during COD movements. COD angle, running speed, contact, and challenge from the opposition were identified as important features related to higher PA_v. This study adds to the literature on the demands of COD performance in soccer match-play. The unique approach with game-specific situational data from female youth players provides increased insight into the game-demands of COD and agility performance. PA_v in games was higher with larger COD angles, increased running speed, or with contact when the player was challenged by the opposition. A larger study including more games is warranted to increase confidence in using these variables as a basis for training or testing agility. Full article

Although injury mechanisms of mild traumatic brain injury (mTBI) may be similar across patients, it is becoming increasingly clear that patients cannot be treated as one homogenous group. Several predominant symptom clusters (PSC) have been identified, each requiring specific and individualised treatment plans. However, objective methods to support these clinical decisions are lacking. This pilot study explored whether wearable sensor data collected during the Buffalo Concussion Treadmill Test (BCTT) combined with a deep learning approach could accurately classify mTBI patients with physiological PSC versus vestibulo-ocular PSC. A cross-sectional design evaluated a convolutional neural network model trained with electrocardiography (ECG) and accelerometry data. With a leave-one-out approach, this model classified 11 of 12 (92%) patients with physiological PSC and 3 of 5 (60%) patients with vestibulo-ocular PSC. The same classification accuracy was observed in a model only using accelerometry data. Our pilot results suggest that adding wearable sensors during clinical tests like the BCTT, combined with deep learning models, may have the utility to assist management decisions for mTBI patients in the future. We reiterate that more validation is needed to replicate the current results. Full article

We have shown that step length asymmetry seen in hip osteoarthritis (OA) is associated with poorer mechanical energy exchange and higher metabolic cost. Thus, we conducted this proof-of-concept study to investigate whether modifying step length through split-belt treadmill training can improve walking energetics. We conducted split-belt treadmill training in four periods with simultaneous motion and metabolic analyses in 10 women with unilateral hip OA. Using repeated measures ANOVA, we evaluated changes across each period, in step length asymmetry, mechanical energy exchange, and O₂ rate. We also examined changes in hip range of motion and peak plantarflexor moment. We used Spearman correlations (rho) to assess the strength of associations between variables at baseline and after adaptation. We found that step length asymmetry and O₂ rate decreased (p = 0.007, p < 0.001) and mechanical energy exchange increased (p < 0.001). Reduced step length asymmetry was associated with reduced O₂ rate (rho = 0.732, p = 0.016). Hip range of motion increased (p < 0.001) and was associated with decreased step length asymmetry (rho = 0.818, p = 0.004), indicating a potential mechanism. These findings suggest that reducing step length asymmetry by split-belt treadmill training could improve walking energetics in hip OA people. Full article

The inability to control the body center of mass (BCM) initial conditions, when executing plyometric exercises, comprises a restrictive factor to accurately compare jumps executed vertically and horizontally. The purpose of the study was to present a methodological approach for the examination of BCM initial conditions during vertical drop jumps (VDJ) and plyometric rebound jumps performed with a pendulum swing (HPRJ). A system consisting of two force plates was used for the evaluation of VDJ. A bifilar pendulum, equipped with a goniometer and accelerometer, was constructed for the evaluation of the HPRJ. Kinematic parameters from both jump modalities were obtained by means of videography (100 Hz). Thirty-eight physically active young males executed VDJ and HPRJ with identical BCM kinetic energy at the instant of impact (KEI). Results revealed that participants produced higher power and lower force outputs at HPRJ (p < 0.01). The rate of force development was larger in VDJ, while hip movement was less in HPRJ. The use of the presented methodology provided the means to reliably determine the exact BCM release height during the execution of the examined jumps. This provided an accurate determination of the amount of KEI, being the main parameter of calculating load during plyometric exercise. Full article

This study aimed to estimate the trunk twist angle from the shoulder and hip rotation angles in short-distance crawl swimming and to elucidate the twist motion of the relationship between the trunk and the rotation angular velocity in response to changes in swimming speed. Swimming speed during the experimental trials was computed from the subject’s best times in the 50 and 100 m crawl swims. Wireless self-luminous LED markers were attached to seven locations on the body. The actual coordinate values of the LED markers were obtained using 18 cameras for underwater movements and 4 on the water for above-water movements. A comparison of the rate of change between trials revealed a high correlation (r = 0.722, p < 0.01) between the twist angle and shoulder rotation angular velocity in the Push phase. In the same phase, a high correlation (r = 0.748, p < 0.01) was also found between the twist angle and the angular velocity of hip rotation. These results suggest that swimmers increase the twist angle of their trunks to obtain a higher swimming speed. Full article

Background: The cutting movement assessment score (CMAS) provides a qualitative assessment of the side-step cutting (S-SC) technique. Previous research has been undertaken primarily by biomechanists experienced with S-SC evaluations. Little is known about the agreement between various sports science and medicine practitioners to ascertain whether the tool can be used effectively by different practitioners in the field. Currently, the CMAS uses three camera views (CVS) to undertake the evaluation, and it would be worthwhile to know whether the CMAS can be effectively conducted with fewer camera views to improve clinical utility. Therefore, the aim of the study was to examine the inter-rater agreement between different sports science and medicine practitioners and agreement between using different CVS to evaluate the S-SC technique using the CMAS. Methods: Video data were collected from 12 male rugby union players performing a 45° S-SC manoeuvre toward both the left and right directions. Five different sports science and medicine practitioners evaluated footage from three cameras of one left and one right trial from each player using the CMAS. Twelve different trials were also evaluated by the sports rehabilitator using single and multiple CVS. Agreements (percentage; Kappa coefficients (K)) between different practitioners and configurations of the CVS were explored. Results: Good to excellent inter-rater agreements were found between all practitioners for total score (K = 0.63–0.84), with moderate to excellent inter-rater agreements observed across all items of the CMAS (K = 0.5–1.0). Excellent agreement was found between using three CVS vs. two CVS that included at least a sagittal view (K = 0.96–0.97). Lower agreement (K = 0.83) was found between angle-frontal views with three CVS. Conclusions: The CMAS can be used effectively by various practitioners to evaluate the movement quality of S-SC. The use of two CVS that include at least a sagittal plane view would suffice to evaluate the S-SC technique against the CMAS. Full article

In many fields of spinal health care, efforts have been made to offer individualized products and therapy tailored to the patient. Therefore, the prevailing alignment of the spine must be considered, which varies from person to person and depends on the movement and loading situation. With the help of patient-specific simulation models of the spine, the geometrical parameters in a specific body position can be analyzed, and the load situation of the spinal structures during dynamic processes can be assessed. However, to enable the future usability of such simulation models in medical reality, as many patient-specific conditions as possible need to be considered. Another critical requirement is that simulation models must be quickly and easily created for use in clinical routine. Building new or adapting existing spine multibody simulation (MBS) models is time-consuming due to their complex structure. To overcome this limitation, we developed a simple, efficient method by which to automatically adjust the lumbar curvature orientation of the spine model. The method extracts a new 3D lordosis curve from patient-specific data in the preprocessing step. Then the vertebrae and all linked spinal structures of an existing spinal simulation model are transformed so that the lumbar lordosis follows the curve obtained in the first part of the method. To validate the proposed approach, three independent experts measured the Cobb angle in the source and the generated spine alignments. We calculated a mean absolute error of 1.29° between the generated samples and the corresponded ground truth. Furthermore, the minor deviation in the root mean square error (RMSE) of 0.0012 m² between the areas under the alignment curves in the original and target lordosis curvatures indicated the accuracy of the proposed method. The proposed method demonstrated that a new patient-specific simulation model can be generated in a short time from any suitable data source. Full article