Next Article in Journal
Effects of Nanosilver and Heat Treatment on the Pull-Off Strength of Sealer-Clear Finish in Solid Wood Species
Next Article in Special Issue
Degradation Behavior of 3D-Printed Residue of Astragalus Particle/Poly(Lactic Acid) Biocomposites under Soil Conditions
Previous Article in Journal
Supercritical CO2 Assisted TiO2 Preparation to Improve the UV Resistance Properties of Cotton Fiber
 
 
Article
Peer-Review Record

Mechanics of 3D-Printed Polymer Lattices with Varied Design and Processing Strategies

Polymers 2022, 14(24), 5515; https://doi.org/10.3390/polym14245515
by Paul F. Egan *, Nava Raj Khatri, Manasi Anil Parab and Amit M. E. Arefin
Reviewer 1:
Polymers 2022, 14(24), 5515; https://doi.org/10.3390/polym14245515
Submission received: 23 November 2022 / Revised: 10 December 2022 / Accepted: 14 December 2022 / Published: 16 December 2022
(This article belongs to the Special Issue Applications of 3D Printing for Polymers 2.0)

Round 1

Reviewer 1 Report

1. Please also use different patterns in the bars in Figures 7, 9, 11, and 15. Otherwise, it's difficult to distinguish the differences when the paper was printed in black and white.

2.  In figures, the font size should be consistent, e.g., Figure 7. 

3. Any physical meaning of Eq. 3? 

Any future work?

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

Please refer to the attached report

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Round 2

Reviewer 1 Report

The authors have already modified the manuscript based on my comments. So, I believe it's ready to be published.

Reviewer 2 Report

The manuscript has been updated accordingly and ready to be accepted for publish. However, there is very minor correction need to be made before publish as below; 

i. All figures need to label (a), (b), (c) etc and not a, b, c &

ii. Please use standard size font for labelling

Back to TopTop