Next Article in Journal
Effects of Combining Graphene Nanoplatelet and Phosphorous Flame Retardant as Additives on Mechanical Properties and Flame Retardancy of Epoxy Nanocomposite
Next Article in Special Issue
Polyaniline-Derived N-Doped Ordered Mesoporous Carbon Thin Films: Efficient Catalysts towards Oxygen Reduction Reaction
Previous Article in Journal
Fabrication of Eco-Friendly Superabsorbent Composites Based on Waste Semicoke
Previous Article in Special Issue
Manufacturing and Characterization of Coatings from Polyamide Powders Functionalized with Nanosilica
 
 
Article
Peer-Review Record

Polymeric Ionic Liquids Derived from L-Valine for the Preparation of Highly Selective Silica-Supported Stationary Phases in Gas Chromatography

Polymers 2020, 12(10), 2348; https://doi.org/10.3390/polym12102348
by Jorge González-Rodríguez 1, Adriana Valls 2, Pilar Arias Abrodo 1, María Dolores Gutiérrez Álvarez 1, Jaime González-Álvarez 1,*, Belén Altava 2,* and Santiago V. Luis 2,*
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Polymers 2020, 12(10), 2348; https://doi.org/10.3390/polym12102348
Submission received: 29 September 2020 / Accepted: 12 October 2020 / Published: 14 October 2020
(This article belongs to the Special Issue State-of-the-Art Polymer Science and Technology in Spain (2020,2021))

Round 1

Reviewer 1 Report

Purity of the used compounds such as for example divinylbenzene and dichloromethane should be reported.

Other conditions of the realized experiments are described correctly.  The methods are adequately described.The staistical analysis was done in the appropriate way. The results and discussion are clearly presented.

Reviewer 2 Report

The authors described an interesting poly(ionic liquid) platform for gas chromatography. The manuscript is well-organized and written. I recommend its publication after the following minor modification.

1 For the application of ionic liquid in the introduction part, the related literature about the application of ionic liquid in materials could be cited, ACS Applied Materials & Interfaces,2017, 9(8), 7217-7223.

2 What is FID?

3 For the synthesis, why did the authors choose 40 centigrade degree as the used temperature?

Back to TopTop