The present study was conducted to ascertain the potential of spent coffee grounds (SCGs) as an alternative adsorbent for the removal of cadmium (Cd) from aqueous solutions. Therefore, Cd adsorption batch tests, using SCGs that had not undergone any chemical pretreatment, were conducted
[...] Read more.
The present study was conducted to ascertain the potential of spent coffee grounds (SCGs) as an alternative adsorbent for the removal of cadmium (Cd) from aqueous solutions. Therefore, Cd adsorption batch tests, using SCGs that had not undergone any chemical pretreatment, were conducted using Cd solutions with a wide concentration range (i.e., 0.1–120 mM) under various adsorption conditions, e.g., ion strength, pH, and solid/solution ratio. For comparison, zeolite, as a well-known common representative adsorbent, was included to determine the adsorption efficiency. The adsorption capacity of the SCGs increased with the decreasing ionic strength of the test solution from 200 to 0 mM of Ca(NO
3)
2 and the increasing solid:solution ratio from 1:4 to 1:400. The most significant factor influencing the adsorption capacity of the SCGs was the pH of the test solution, with increases in the adsorption capacity as the initial solution pH was increased from 2 to 10. However, the rate for Cd removal remained constant, at 71.19%, when the initial solution pH was between 4 and 8 due to the buffer capacity of SCGs. The obtained data were fitted with the
Freundlich,
Langmuir, and
Dubinin-Radushkevich isotherm models. The Langmuir isotherm provided the best correlation for Cd adsorption onto SCGs (R
2 = 0.96) and zeolite (R
2 = 0.92), and the maximum Cd adsorption capacity of the SCGs was 19.32 mg g
-1, which was higher than that of zeolite (13.91 mg g
−1). These results mean that the SCGs can be utilized as alternative low-cost biosorbents to replace conventional adsorption materials.
Full article