Search for Articles:
Title / Keyword
Author / Affiliation / Email
Journal
Article Type
 
 
Advanced Search
 
Section
Special Issue
Volume
Issue
Number
Page
 
3.9
2.5
Journals
Colloids and Interfaces
Special Issues
Crude Oil Recovery
share announcement

Crude Oil Recovery

A special issue of Colloids and Interfaces (ISSN 2504-5377).

Deadline for manuscript submissions: 30 November 2024 | Viewed by 12300

Special Issue Editor

Dr. Plamen Tchoukov

E-Mail Website
Guest Editor
Institute of Physical Chemistry, Bulgarian Academy of Sciences, 1113 Sofia, Bulgaria
Interests: emulsion and foams; thin liquid films; interfacial and bulk rheology; heavy crude oil; petroleum emulsions; electrochemical impedance spectroscopy of thin film; self-assembly
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

For more than a century, crude oil has satisfied a large fraction of the world’s energy consumption. Even though humankind is currently focused on the transition to renewable and more environmentally sustainable alternatives, there remains an expectation that the demand for crude oil will increase in the near future and that it will continue to play a significant role in decades to come. With increased oil demand and the depletion of conventional oil resources, the last few decades were characterized by a boom of new technologies that allowed for the recovery of previously inaccessible oil resources. At the same time, under more stringent environmental regulations and targets, the petroleum industry is advancing new technologies to reduce environmental impacts like greenhouse gas emissions and water usage. In many respects, this technological progress has been based on research and knowledge related to colloid and interface science. For this Special Issue, we invite contributions related to crude oil extraction, processing, and transportation, as well as related environmental risks/impacts and mitigation methods.

Dr. Plamen Tchoukov
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Colloids and Interfaces is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • crude oil composition and properties
  • phase behaviour
  • rheology
  • multiphase flow
  • asphaltene aggregation
  • petroleum emulsions and stabilization mechanisms
  • interfacial phenomena
  • enhanced oil recovery
  • heavy oil
  • fouling
  • environmental aspect and risk/impact mitigation
  • oil spills

Benefits of Publishing in a Special Issue

  • Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
  • Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
  • Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
  • External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
  • e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.

Further information on MDPI's Special Issue polices can be found here.

Published Papers (5 papers)

Download All Papers
Order results
Result details
Show export options expand_more Show export options expand_less
Select all
Export citation of selected articles as:

Research

19 pages, 7477 KiB  
Article
Effect of Asphaltenes and Asphaltene Dispersants on Wax Precipitation and Treatment
by Oualid M’barki, John Clements and Quoc P. Nguyen
Colloids Interfaces 2024, 8(3), 30; https://doi.org/10.3390/colloids8030030 - 14 May 2024
Viewed by 1503
Abstract
A detailed understanding of the interactions between wax and asphaltenes with other components of crude oils and the effect of treatments with paraffin inhibitors (PIs) and asphaltene dispersants (ADs), with a focus on identifying specific structure-activity relationships, is necessary to develop effective flow [...] Read more.
A detailed understanding of the interactions between wax and asphaltenes with other components of crude oils and the effect of treatments with paraffin inhibitors (PIs) and asphaltene dispersants (ADs), with a focus on identifying specific structure-activity relationships, is necessary to develop effective flow assurance strategies. The morphological and rheological consequences of treating wax and asphaltenes in oils of differing composition with a series of ADs having structural features in common with an alpha olefin-maleic anhydride (AO-MA) comb-like copolymer PI were assessed alone and in combination with said PI. Of the four ADs studied, two were identified as being effective dispersants of asphaltenes in heptane-induced instability tests and in a West Texas (WT) crude. The degree to which a low concentration of asphaltenes stabilizes wax in the absence of treatment additives is lessened in oils having greater aromatic fractions. This is because these stabilizing interactions are replaced by more energetically favorable aromatic–asphaltene interactions, increasing oil viscosity. Treatment with AD alone also reduces the extent of wax–asphaltene interactions, increasing oil viscosity. In concert with the PI, treatment with the AD having greater structural similarity with the PI appears to improve wax solubility in both the presence and absence of asphaltenes. However, the viscosity of the treated oils is greater than that of the oil treated with PI alone, while treatment with AD having lesser structural similarity with the PI does not adversely affect oil viscosity. These data suggest that rather than treating both wax and asphaltenes, AD may poison the function of the PI. These data illuminate the pitfalls of designing flow assurance additives to interact with both wax and asphaltenes and developing treatment plans. Full article
(This article belongs to the Special Issue Crude Oil Recovery)
►▼ Show Figures

Graphical abstract

22 pages, 5203 KiB  
Article
Oil/Brine Screening for Improved Fluid/Fluid Interactions during Low-Salinity Water Flooding
by Jose Villero-Mandon, Peyman Pourafshary and Masoud Riazi
Colloids Interfaces 2024, 8(2), 23; https://doi.org/10.3390/colloids8020023 - 1 Apr 2024
Cited by 2 | Viewed by 1669
Abstract
Low-salinity water flooding/smart water flooding (LSWF/SWF) are used for enhanced oil recovery (EOR) because of the improved extraction efficiency. These methods are more environmentally friendly and in many scenarios more economical for oil recovery. They are proven to increase recovery factors (RFs) by [...] Read more.
Low-salinity water flooding/smart water flooding (LSWF/SWF) are used for enhanced oil recovery (EOR) because of the improved extraction efficiency. These methods are more environmentally friendly and in many scenarios more economical for oil recovery. They are proven to increase recovery factors (RFs) by between 6 and 20%, making LSWF/SWF technologies that should be further evaluated to replace conventional water flooding or other EOR methods. Fluid/fluid interaction improvements include interfacial tension (IFT) reduction, viscoelastic behavior (elastic properties modification), and microemulsion generation, which could complement the main mechanisms, such as wettability alteration. In this research, we evaluate the importance of fluid/fluid mechanisms during LSWF/SWF operations. Our study showed that a substantial decrease in IFT occurs when the oil asphaltene content is in the range of 0% to 3 wt.%. An IFT reduction was observed at low salinity (0–10,000 ppm) and a specific oil composition condition. Optimal IFT occurs at higher divalent ion concentrations when oil has low asphaltene content. For the oil with high asphaltene content, the sulfates concentration controls the IFT alteration. At high asphaltene concentrations, the formation of micro-dispersion is not effective to recover oil, and only a 5% recovery factor improvement was observed. The presence of asphaltene at the oil/low-salinity brine interface increases the energy required to disrupt it, inducing significant changes in the elastic moduli. In cases of low asphaltene content, the storage modulus demonstrates optimal performance at higher divalent concentrations. Conversely, at high asphaltene concentrations, the dominant factors to control the interface are paraffin content and temperature. Full article
(This article belongs to the Special Issue Crude Oil Recovery)
►▼ Show Figures

Figure 1

22 pages, 3813 KiB  
Article
Factors Influencing the Rheology of Methane Foam for Gas Mobility Control in High-Temperature, Proppant-Fractured Reservoirs
by Aashish T. Parekh, Amit Katiyar and Quoc P. Nguyen
Colloids Interfaces 2024, 8(1), 13; https://doi.org/10.3390/colloids8010013 - 4 Feb 2024
Viewed by 1898
Abstract
Gas-enhanced oil recovery (EOR) through huff-n-puff (HnP) is an important method of recovering oil from fracture-stimulated reservoirs. HnP productivity is hampered by fracture channeling, leading to early gas breakthroughs and gas losses. To mitigate these issues, foam-generating surfactants have been developed as a [...] Read more.
Gas-enhanced oil recovery (EOR) through huff-n-puff (HnP) is an important method of recovering oil from fracture-stimulated reservoirs. HnP productivity is hampered by fracture channeling, leading to early gas breakthroughs and gas losses. To mitigate these issues, foam-generating surfactants have been developed as a method of reducing injected gas phase mobility and increasing oil recovery. This work investigates foam generation and propagation by a proprietary surfactant blend in high-temperature, high-pressure, high-permeability, and high-shear conditions that simulate the environment of a proppant-packed fracture. Bulk foam tests confirmed the aqueous stability and foaming viability of the surfactant at the proposed conditions. Through several series of floods co-injecting methane gas and the surfactant solution through a proppant pack at residual oil saturation, the effects of several injection parameters on apparent foam viscosity were investigated. The foam exhibited an exceptionally high transition foam quality (>95%) and strong shear-thinning behavior. The foam viscosity also linearly decreased with increasing pressure. Another flood series conducted in an oil-free proppant pack showed that swelling of residual oil had no effect on the apparent foam viscosity and was not the reason for the inversely linear pressure dependency. An additional flood series with nitrogen as the injection gas was completed to see if the hydrophobic attraction between the methane and surfactant tail was responsible for the observed pressure trend, but the trend persisted even with nitrogen. In a previous study, the dependence of foam viscosity on pressure was found to be much weaker with a different foaming surfactant under similar conditions. Thus, a better understanding of this important phenomenon requires additional tests with a focus on the effect of pressure on interfacial surfactant adsorption. Full article
(This article belongs to the Special Issue Crude Oil Recovery)
►▼ Show Figures

Figure 1

15 pages, 4006 KiB  
Article
Foam Stabilization by Surfactant/SiO2 Composite Nanofluids
by Fariza Amankeldi, Miras Issakhov, Peyman Pourafshary, Zhanar Ospanova, Maratbek Gabdullin and Reinhard Miller
Colloids Interfaces 2023, 7(3), 57; https://doi.org/10.3390/colloids7030057 - 7 Sep 2023
Cited by 4 | Viewed by 2459
Abstract
This paper deals with the potential of aggregates of surfactant and SiO2 nanoparticles as foam stabilizers for practical applications. The effects of different chain lengths and concentrations of the cationic surfactant CnTAB on the performance of CnTAB–SiO2 [...] Read more.
This paper deals with the potential of aggregates of surfactant and SiO2 nanoparticles as foam stabilizers for practical applications. The effects of different chain lengths and concentrations of the cationic surfactant CnTAB on the performance of CnTAB–SiO2 nanofluids are examined to gain a comprehensive understanding of their ability to stabilize foam. The results indicate enhanced foam stability in the presence of SiO2 nanoparticles. These findings help to better understand foam stabilization and its potential in various industrial applications such as enhanced oil recovery and foam-based separation processes. Full article
(This article belongs to the Special Issue Crude Oil Recovery)
►▼ Show Figures

Figure 1

15 pages, 5026 KiB  
Article
Impact of Paraffin Composition on the Interactions between Waxes, Asphaltenes, and Paraffin Inhibitors in a Light Crude Oil
by Oualid M'barki, John Clements, Luis Salazar, James Machac, Jr. and Quoc P. Nguyen
Colloids Interfaces 2023, 7(1), 13; https://doi.org/10.3390/colloids7010013 - 6 Feb 2023
Cited by 6 | Viewed by 3757
Abstract
The effect of wax molecular weight distribution on the efficacy of two alpha olefin-maleic anhydride paraffin inhibitors (PIs) having different densities of alkyl side-chains were examined in light West Texas crude in the absence and presence of asphaltenes. Interpretation of the data was [...] Read more.
The effect of wax molecular weight distribution on the efficacy of two alpha olefin-maleic anhydride paraffin inhibitors (PIs) having different densities of alkyl side-chains were examined in light West Texas crude in the absence and presence of asphaltenes. Interpretation of the data was aided by cross-polarization microscopy. Primary differences in wax crystal morphology appear to be driven by the composition of the wax, with secondary differences being associated with the choice of PI. In the absence of asphaltenes, the effect of wax composition on PI performance (i.e., reducing oil viscosity and wax appearance temperature) is greater for the PI having the higher chain density, with the one having the lower chain density being generally more effective regardless of the wax composition. These differences are diminished in the presence of asphaltenes such that the PI having the higher chain density is somewhat more effective. Trends in both morphology and viscosity suggest a steric effect associated with wax composition that is lessened on interaction of the PIs with asphaltenes. Full article
(This article belongs to the Special Issue Crude Oil Recovery)
►▼ Show Figures

Figure 1

Show export options expand_more Show export options expand_less
Select all
Export citation of selected articles as:
 
Displaying articles 1-5
Back to TopTop